Questions & Answers for: coffee too thin - Page 8

coffee reservoir. Using a flathead screwdriver, pop off the helmet-looking cover attached to the cover's hinge. Put a thin flat piece of rubber no thicker than 1/8" into the helmet. Replace the helmet

...thin stainless filter gets stuck over time to the machine body by a build-up of coffee grounds and oil, put a finger a small amount into the hole left by the removed bolt to get an edge of the filter ...

coffee (lavazza, ground with Capresso Infinity) my Gaggia Evolution was making a loud noise and did not give a drip. After that, the 'Mouse tail" is always too thin even with coarsely ground beans and

coffee is hot that means the machine works fine and the only problem you have the tube nozzle clogged. So first switch of the machine a turn the knob to off position. Remove the steam nozzle cover and

...coffee will leak while pouring. This o-ring binds against the carafe. To fix this, locate the 'O' ring in that same part the extends into the carafe on the bottom of the lid. put a drop or two of ...

cup not filling up There are 3 needles on the underside of the lid and one on the bottom of the kcup holder. Using a thin "uncoated" paper clip, straighten the clip and insert it into the hollow ...

Outlet pipe blocked. Descaling not helped. You may have to clear the hole with some sort of thin probe, if you have a very small drill bit you can use that. You are only drilling out the hardened milk

...coffee then the element is fine and the suspect part is the Thermistor. Another forum suggested this was a Vishnay NTCLG100E22245B, available from DigiKey (their part # BC2467), connected to the ...

...coffee instead of dropping it into basket! any suggestions? I'm guessing there is a funnel under the grounds discharge port and your not using a bowl to collect the grounds. (some places do this to ...

Error code OA on Krups EA8080 OA means that the sensor is not detecting any heat in the boiler. That means either the boiler is not heating or the sensor or sensor wire is detached from the boiler or ...