20 Most Recent
Eco-Friendly Franklin Low Bookshelf - Page 2 Questions & Answers
SEIKO MUSICAL WALL CLOCK WILL NOT AUTOMATICALLY PLAY
Old Question!!There is a switch in the back to allow you to switch the melody off at night when you go to bed. Some are also light sensitive to test for the dark automatically via a photo-cell..To test your Seiko Melodies in Motion Clock:1) Check the volume knob in the back of the Seiko clock to make sure the volume has not been adjusted all the way down.2) Make sure the on / off switch is set to on.3) If it is extremely dark in the room, the clock will not play, it has a light sensor. Make sure the room is well lit.4) There are separate batteries usually that operate the clock and the music. Change the batteries paying special attention to any acid / corrosion caused by old batteries. Clean out any acid and it should play. Also, be careful not to touch the positive or negative contacts on the new batteries, as this could inhibit proper connection...
4/20/2025 3:22:48 AM •
Home
•
Answered
on Apr 20, 2025
Gear slips will not open a can
They aren't repairable, you just buy a new one. Sometimes it is the design of the can.FULL 'make model (what it is)' in all questions please...
3/19/2025 6:59:17 PM •
Home
•
Answered
on Mar 19, 2025
Why do people use meat thermometers?
: Meat thermometers
are great ways to measure the internal temperature of meat while it's cooking. It allows an easy and yet accurate way of
knowing if the meat is cooked.
2/13/2025 1:47:08 PM •
Home
•
Answered
on Feb 13, 2025
I have the MZ Berger Sharp SPC1010ODX Atomic Clock. It will not set to the correct time. Is there any way to set it Manually?
To manually set your MZ Berger Sharp SPC1010ODX Atomic Clock, follow these steps:
- Insert Batteries: Place two AA batteries into the battery compartment, ensuring correct polarity. The clock will display the time and date, and the atomic signal icon will flash, indicating it's searching for the atomic time signal.
- Access Manual Time Setting Mode:
- Press and hold the TIME SET button until the hour digits flash.
- Use the UP or DOWN buttons to adjust the hour.
- Press the TIME SET button again to move to the minute setting.
- Adjust the minutes using the UP or DOWN buttons.
- Press the TIME SET button once more to confirm the time setting.
- Set Date and Day of the Week:
- Press and hold the CAL. SET button until the year digits flash.
- Adjust the year using the UP or DOWN buttons.
- Press the CAL. SET button to move to the month setting, then adjust accordingly.
- Continue pressing the CAL. SET button to set the day of the week and day of the month.
- Press the CAL. SET button to confirm each setting.
- Set Time Zone and Daylight Saving Time (DST):
- Press and hold the TIME ZONE button to select your time zone.
- Press and hold the DST button to enable or disable DST, depending on your location.
After completing these steps, your clock should display the correct time and date.
2/10/2025 6:16:33 PM •
Home
•
Answered
on Feb 10, 2025
Only the handle gets hot.. help what the hrll
ReformasValencia10 es una plataforma especializada en ofrecer soluciones integrales para reformas en Valencia. Nos dedicamos a transformar espacios, adapt?ndolos a las necesidades y preferencias de cada cliente. Ya sea una reforma de ba?o, cocina, sal?n o una renovaci?n completa, trabajamos con los m?s altos est?ndares de calidad.reformas valencia
1/8/2025 3:38:30 AM •
Home
•
Answered
on Jan 08, 2025
Not finding what you are looking for?
