20 Most Recent
Waxmaster Waxsmaster 99402 10" Random Orbit Waxer Polisher 2400rom - Page 3 Questions & Answers
Medicool 20k pro drill how to fix after 2 balls install?
If you have installed the ceramic balls in your Medicool 20K Pro Drill, and now it is not working, you may need to perform the following steps to fix it:
- Remove the handpiece from the control box.
- Unscrew the two small screws on the front of the handpiece.
- Gently remove the front cover of the handpiece.
- Remove the two ceramic balls from the spindle.
- Reassemble the handpiece by replacing the front cover and securing it with the screws.
- Reconnect the handpiece to the control box and test it.
If the drill still does not work, it may be a problem with the control box or another component. In that case, it may be necessary to contact the manufacturer or a professional repair technician for further assistance.
How to reload a Bostitch H2B hammer stapler?
They are hard to come by but you swivel a little clip in the front and then a small door comes up. You then insert the staples in-between the solid meatal bit(bottom) and the small meatal foot (top), you should feel spring resistance. If you see this I hope it helps.
How to fix Apsco 17 stapler with a detached spring?
To fix an Apsco 17 stapler with a detached spring, you will need to reattach the spring to the stapler. Here is a general process you can follow to do this:
- Unplug the stapler and lay it on a flat surface.
- Locate the spring and the area where it attaches to the stapler. This may be near the back of the stapler or on the underside.
- Using a small tool, such as a flathead screwdriver or a pair of needle-nose pliers, gently pry open the area where the spring attaches. This will allow you to access the spring.
- Hold the spring in place with one hand, and use the other hand to carefully attach the spring to the stapler. Be sure to align the spring with the correct attachment point, and apply gentle pressure to secure it in place.
- Once the spring is reattached, test the stapler to make sure it is functioning properly. If the stapler still does not work properly, you may need to consult a professional repair technician for further assistance.
Tension lever for nu-tools wood lathe
ask maker this. (or seller)
the lathe came with a manual , lost that/
and on the last page it shows contacts list , read that
?
or google for makers support.
moved you out of cars to tools.
Paslode fan won't turn on
what color is the light when you insert battery? then what color is it when you try and fire the tool? you could have a couple problems, first does the light even come on? If not the battery contacts might be bad. second you got light but no fan, could be a spark plug wire, bent lower probe circuit board bad and lastly bad fan motor. Let me know about the lights first and we will go from there
Not finding what you are looking for?
