I HAVE A COOL START REMOTE # M65TX605 THAT NEEDS TO BE REPROGRAMMED. IT WAS WORKING A COUPLE OF DAYS AGO BUT WHEN I TOOK IT OUT MY POCKET THE LIGHT WAS FLASHING. NO BUTTONS WERE PUSHED SO I BELIEVE IT ENTERED INTO THE PROGRAMMING PHASE AND I DID NOT GET THAT INFO FROM THE INSTALL DEALER.
From http://www.crimestopper.com/techweb/InstructionBooks/RemoteStart/rs1300dp_1304dp_a_ops.pdf Note: All transmitter codes must be learned at time of programming!! The unit will learns up to 4 different transmitter codes. 1. Open Hood (If no hood pin installed with your system, then you must ground the Gray Hood pin wire). 2. Turn key to the ON position. (Pink wire must be connected.) 3. Press Programming button 4 times, then after a few seconds the unit flashes the parking lights 4 times. 4. Press button #1 of the transmitter to be coded. You should get 2 light flashes indicating the unit is waiting for a 2nd code, then press button #1 of a second transmitter, the unit will flash 3 times indicating its waiting for the 3rd code and so on. If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key off and close hood. See diagram below.
So this morning i tried to remote start my truck the truck turned on and it stayed on for 5 sec turned off again 3 sec later it turned on again for 5 sec and turned off agin doin the same problem over and over any ideas what this problem can be>? its the cool start idk which model # i bought the truck with it
My remote was droped the buttons on the side will cause the light to come on but the rest of the buttons wont do anything at all how can i fix this
19,217 views
Usually answered in minutes!
remote works for a couple weeks with new batteries then does not lock doors or start however the blue light still works. ???
×