Charging a razor epunk

SOURCE: Won't charge up, won't run

uh...the charger's supposed to have a DC output

SOURCE: e-100 razor scooter battery will not take charge

its dead they need to be recharged every time they have been used

shaveroutlet.com

• 1652 Answers
• Posted on Jun 10, 2010

SOURCE: razor wont charge

Yes, the batteries can be changed. You will find replacement batteries for model 6705X at shaveroutlet.com. See link below

http://shaveroutlet.com/shaver-battery-pack-for-most-norelco-more-p-278.html

To change the batteries, you will need to remove the lotion cartridge cover on the back and then remove the screws on the back of the inner cover. Remove the back to get to the inside of the shaver. The batteries are soldered to the circuit board. You can unsolder them or it is sometimes suggested that you use a modified installation technique. This is to break the tabs off of the old batteries rather than unsoldering them from the circuit board. This allows the old batteries to be removed but leaves the tabs attached to the circuit board. You can then solder the tabs from the new batteries to the old existing tabs. Reassemble in reverse order

If you are not able to do this repair yourself, shaveroutlet.com can do it for you. See link below

http://shaveroutlet.com/professional-battery-replacement-for-most-models-p-374.html

SOURCE: razor bella problems

Most likely a bad battery. Check out put voltage on all posts. If it's 12 Volts DC or more, then it should be ok, and you'll need to start looking in the wiring such as the speed control switch. If not, your problem is a bad battery cell and you should replace it. NEVER TRY TO SERVICE A BATTERY!!!!!