Hi,
this is a problem in scaning lamp,check the cable which is connected from scaning lamp to pcb is damaged or discontinued ,so replace it but the fault will be rectified replace the pcb,then contact service dealer
It means thermistor open.
Perform the following procedure to enter the simulation mode.
"C" key AUTO/TEXT/PHOTO key
"C" key AUTO/TEXT/PHOTO key
Main code Start key Sub code Start key
(Note:Perform the first four key strokes
If the machine die enter 14, press start the machine wil reboot.
if not the fuser assembly needs repiaring
Eror code L 6
Can you state the exact Brand & model ( if it is Sharp then the problem is in heater lamp)
253 views
Usually answered in minutes!
×