The display flashes 'H'., alternating with the number of copies from the last job. No buttons or keys respond. Tried power on and off a few times, no change.
I see the user manual says contact your SHARP service center immediately and is no further help. But a bit of websearching revealed Error Codes Starting with "H" are fuser faults. H2-00 Fusing unit temperature error If you haven't got the user manual it is here:- http://www.sharpusa.com/files/cop_man_AR162S.pdf Importantly it shows how to release the fusing unit. If you cant see an obvious problem then you may need to get a new fusing unit. You may need to reset the copier to clear the error so it can try starting again when you switch on.
H3-00 Overheated fusing unit
H4-00 The fusing unit doesn't heat up
I've just obtained the service manual I can send you a copy if you drop me a line at fix@sparkgap.co.uk
×
165 views
Usually answered in minutes!
×