I have this sxrd projection for 6 months.suddenly,while watching a tv show,the picture disapeared but sound remained,a green light continouosly blinked,i pressed on the ON button and suddenly the sound also disappeared and the blinking green light became red which flashed 5 times for every 2sec interval.i switched off the tv,after a while pulled out the plug.after 30minutes tried to turn on the tv but won't start anymore with the standby button flashing red 5 times for every interval
I think this sounds like my problem (need to replace the projector lamp). However, when I hit the "on" button, my SXRD 50" blinks green for about a minute then starts blinking red. Can you confirm the bulb solution? I was very pleased with this sight when my fan malfunctioned. I got the fan in a matter of day's from Sony and it fixed that problem.
Stadby Red Light flashing for 3 times every 2 seconds.
Solution: Unplugged the tv from powerstrip and placed it into wall by itself. Removed the lamp part 5100 as mc32vol (thanks for the tip), checked and made sure that the lamp wasn't broken and replaced it. TV turned on no red light blinking. Kids are Happy Bryan from Bakersfield Ca
Have to replace the lamp... part 5100... it's on the left side of the TV (if you are working from the back of the TV). there is one small screw that secures the door to the television. once you remove that door,the lamp is righ there with the labels that say pull... rempove this part. you'll likely see the shattered bulb on the inside. replace this part and the TV should be as good as new. you will have to call around to find one in stock though. the cost of the lamp is right around $250.00
this works for 50 in as well
Lamp driver, I just had my tv serviced and it was the same symptom, but now i have 4 flashing lights. OMG 560.00 yestureday and now this, Oh so lovely.
3,623 views
Usually answered in minutes!
I the same problem 5 blinking red lights. I tried replacing the lamp and still have the same problem please help
My 60" is similar. On power up, green flashes for a minute or so, and changes to red. Blinks 5 times and waits, 5 times and waits...
Someone in another post said the svc manual states this infers a bad lamp driver... Can anyone confirm? If so, is that something anyone can fix or is this definitely a service call?
×