My reed valve is broke on my Paslode 350 could this cause the firing pin to stick ?

SOURCE: Firing pin not retracting far enough to allow nails forward

Yes,this is a common "mis fire" by Pasilode. I own the 16p Framer and the Angle nailer and I never get it from the Framer but I do get it seldom from Trim Gun,nothing you can do ,its just a misfire.

Please rate jj505

SOURCE: paslode 350 wont fire

Hi,
Probably needs cleaning. You`ll need two new o`rings.

SOURCE: paslode framing nailer when fired pin stays out wont retract

Check the anvil guide for damage first (ie: burrs, nicks, etc.) Then go to the chamber for the return spring. That is where your problems are.

SOURCE: Paslode (30 degrees) framing gun firing pin not retracting

The tool needs to be completely torn down, cleaned out, two orings inside need replaced, re-lubed and re-assembled. takes a technician about 1 hour to do it right. I believe either the orings or dirt is your problem. If blade doesn't return its probably the orings.

SOURCE: my paslode angled finishing gun keeps jamming

Hi,

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

';';][