E012 code - Canon NP 6085 Copier

You may need a maintenance kit . Check right side interlock It my be broken.

I’m happy to help further over the phone at https://www.6ya.com/expert/joshua_ac64e182ed26f66d

http://totalpos.co.nz/wp-content/uploads/2012/10/Casio-SE-S300.pdf

From page 88 onward...

Cheers

Hi. Can you tell me what the rest of the message reads? Each error code has a message displayed as well.

what is solution

CLC1150 problem code E020 0181

what is this? The machine has been off/on and we also this problem

info@setobemmel.nl

E012-0001 Error code At about 37 sec. after the power is turned ON, due to a drum ITB motor failure


Symptom About 37 sec. after the power is turned ON, E012-0001 is displayed due to a drum ITB motor failure. Cause Rotational failure of drum ITB motor Items to Check 1) In service mode level 1 COPIER > FUNCTION > PART-CHK > MTR, enter 1 and press the OK key.
2) In service mode level 1 COPIER > FUNCTION > PART-CHK > MTR-ON, press the OK key to check whether the motor is working normally.
3) Check whether 24V is supplied to J93 on the ITB drum motor. If yes, the ITB motor likely faulty.

4) If 24V is not supplied to the ITB drum motor, check whether 24V is output from fuse PCB J70-3 to the ITB drum motor.
Also, check whether 24V is output from the fuse PCB J71-1 to the microswitch PCB and also whether 24V is supplied to the fuse PCB J71-2 from the microswitch PCB.

5) If there is no problem between the fuse PCB J71-1, -2 and the microswitch PCB, the fuse PCB is likely faulty.
If 24V is output from the fuse PCB J71-1 to the microswitch PCB and not supplied to the fuse PCB J71-2, check the microswitch PCB. Field Remedy Replace the drum ITB motor.

FH6-1971 DC Brushless Motor

Hello sir; Looks like the drum motor have problem, open back cover find out drum motor and look around have any gear broke if everything fine then replace motor that is necessary.

It is a Drum Drive system over load/ or Drum Motor issue/ DC pcb issue. Need to check drum blades for all colors or if Dev. units are locked up.

You could very well have a worn registration clutch, it's behind the the gray roller that sits to the right under the drum. Good luck! If that doesn't do the trick you may have to change your transfer settings in service mode

I guess I have to use my psychic powers to see what machine it is.....................................................................................
Canon ...........E020 toner feed problem
E012..................?????? ( not in the canon error code list........E010 & E011 Drive problem)