SOURCE: i have a speedline 180 amp arc welder and it
Check for output voltage (ac or DC depending on model).No voltage,welder has a problem.
You must have a clean ground clamp attached to bare metal with some welders to make them work.
SOURCE: looking for owners maual for Craftmans industrial ac/arc welder
You can find the manuals for sale for almost all Craftsman units at sears.com and navigate to the craftsman site and then to customer service parts and enter the model number and they will typically show you a parts breakdown of the unit and also offer replacement manuals for sale. Hope This Helps Don
SOURCE: Tig welder wont strike up arc, power to welder ok,
www.millerwelds.com › Products › TIG -
www.millerwelds.com › Service & Support
SOURCE: M lincoln 225 arc welder runsfan comes on but will
Transformer is burned out. Various windings are taken off at different points to alter the amount of power, they have eventually burned right through , So that is why some worked and some didn't It has now completely gone. The cost to replace the transformer may well exceed the cost of a new welder.
Please rate my help++++Thanks for using FIXYA
SOURCE: I have a old pipeliner
Hi,
The same thing happen as if you overloaded it. The diodes are fried...
heatman101
246 views
Usually answered in minutes!
×