Questions & Answers for: OKI align to form Computers & Internet

Oki Microline 320 Turbo page alignment We have several Oki 320's that seem to lose TOF while printing. If we reset TOF the first page prints correctly, but each page that follows starts printing ...

...your platen probably has flat spots on it. This can be caused when someone forget to perform an alignment on a PH. To run a test page you can power off the printer. Hold down the LF key and power ...

Okidata - label printing alignment I am trying to print single column continuos form lables (Avery 4013) using MS Word label printing option on the 320 turbo and the printer head will only start ...

...the tractor feeds and, over time, these belts wear, break, become smooth and slip, or become misaligned. Environment can also contribute. Paper stored in a warehouse can weaken in intense heat or ...

...on blank paper until you get it dialed in. Hold up to light and lay labels over or under it to see ...

align the edge of the paper with the appropriate reference mark (1). Then, push back the lock lever. 32T-29A.eps 6 Adjust the position of the right tractor to center the holes in the paper on the pins

the letters aren't formed then the print head is not working well, which means that either it's missaligned, i.e it's a bit higher than it should be, or, it's broken and you'll need a replacement head

Form to mis-align. Always turn the printer off before turning the platen knob! 1 Turn the printer ON. 2 Park the paper. 3 With paper out of the unit, (red alarm light should be on) press SHIFT (1) and

...Make sure the paper is feeding correctly through the printer and that the paper guide is properly aligned. If the paper is not being fed correctly, it can cause the printer to jump around. Check