Questions & Answers for: Mitsubishi batch code Computers & Internet

...power on...I see several posts with the same problem mine was manufactured in 2003, can it be a bad batch? do self test at ...

... $250 labor. is it worth it? is there anything else i can do? thank you. I was told there was a bad batch of capictors so we reaplaced all of them and still the blinking green light ,and no tv still ...

...sensor? The sensor is usually right by the lamp, somewhere by the housing. There were a few bad batches of temp sensors and some others where the temp sensor connector went bad (hardwiring fixed ...

...Dodge and Oldsmobile? These are the past cars I owned, all baught new... There probably a whole batch of them from the factory that weren't prepped right for the final coat... I think it's a ...

...used or new thanks. First of all, I'd flush out the old auto tranny with one brand new ATF fluid batch, run it a 5-10 miles, drain it again. Put in the right amount of new ATF afterwords (Should ...

...off my 2004 black galant thats a sign of not enough clearcoat from the factory or just a bad batch. i would bring it in to the dealership and tell them cause there might be a bulliton on it

...then TV shuts off, red blinks, lamp is bad. I just had to replace lamp twice, due to defective batch of lamps with housing. 3rd time I replaced bare bulb and it solved the problem. But there was ...

...ordered lamps lasted less than three months and this last one only lasted 23 days. Did I get a bad batch of lamps or is there something more going on with the TV? If a OEM Mitsubishi lamp was used ...

...be a drop in fuel pressure or bad fuel dont panic it can be as simple as a blocked filter or a bad batch of fuel. Can you give more details ie did u fill up few days before or when was last major ...

...under warranty your first call should be to the dealer who sold the unit. It may be part of a bad batch. The dealer should take responsibility for replacing the unit or contacting the ...