Questions & Answers for: Weber burner knobs Home

...burner control knobs and the cylinder valve OFF. Disconnect the regulator from the cylinder. Turn burner control knobs to HIGH. Wait at least 1 minute. Turn burner control knobs OFF. Reconnect the ...

burner control knobs in the ?ON? position when the LP cylinder valve is opened. The second is not to wait long enough to ?start? the grill after opening the LP cylinder valve. The safety device in the

center control knob/burner Yesterday I noticed my center burner wasn't working. After a few minutes I saw a small flame under the center control knob. I turned the knob off, with some difficulty. Any ...

...burner control knobs and the cylinder valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to high. Wait at least 1 minute . Turn burner control knobs OFF. Reconnect the ...

...burner control knobs and the cylinder valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to high. Wait at least 1 minute . Turn burner control knobs OFF. Reconnect the ...

...burner control knobs and the cylinder valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to high. Wait at least 1 minute . Turn burner control knobs OFF. Reconnect the ...

to the grill, just before you hit the ignighter no gas comes out make sure there isn't a designated burner for lighting. sometimes there will only be 1 burner the grill will light. start with all them

...of gas. Try this. 1. Turn gas tank and burner control knobs off. 2. Turn tank valve on VERY slow. 3. Open front burner knob on and lite grill. Wait a minute and turn on addition burners, (if

...knobs removed but one, the middle sear station knob. Like the directions told me, I pulled each knob out but the sear station knob seems to be different. It appears that there is a spring which is ...

My Weber gas grill knob on back burner melted. I replaced burner. Front works fine. Back burner knob melted twice. Question edited for clarity, so few words, so many mistakes :>D Question moved ...