...knobs white smoke came out around the sides of the knob. It would go away when the knob was turned off. Sounds like a short in that particular burner circuit. Usually when the light stays on even ...
Dead burner on kitchenaid gas cooktop? I've got a KitchenAid KGCT305BBL 4 burner gas-on-glass cooktop and the left front burner has stopped working completely. The other three work fine. This one does
...burner rings. Remove control knobs. In the event that the hob is built in, undo the bracket clamps underneath the work surface. Lift the hob on to the work surface. Unscrew the venturis on the ...
...burner lights other burners will work but clicking wont stop clean the knob control by using vaccium,pull the knobs then clean it.make sure how to remove the knob,same position to returrn the ...
...burner. Each of the other three knobs do cause a spark at each of the four burners at the same time. If this cooktop was better designed this would never have happened. There is absolutely nothing to ...
Question about 30 in. JGP326 Gas Cooktop
turn as stated in manual. I have to turn the knob past "lite" before flame comes on. Is it just one burner knob that does that are all of them? If it is just one then the igniter switch built into the
R rear burner not sparking When RR knob is turned to "spark", there is no spark on RR burner. But, when I turn R front knob to "spark", both RR and RF burner spark - since there is no gas to RR burner
...knobs ? (1) Get Naval Jelly (Rust dissolver) and apply on the igniter and than see if everything is fine. (2) Check the connections from the knob to the burner. Probably have a leak. Replace the wire ...
Question about 30-inch Electric Ceramic Glass Cooktop with Schott Ceran Surface
Whirlpool How To My Whirlpool electric cooktop Model RCC3024 Front left burner not working. Not sure if its the knob or burner since before the burner stopped working, I used to be able to maneuver ...
Question about 30-inch Electric Ceramic Glass Cooktop with Schott Ceran Surface
burner but at the knob. I've tried switching the knobs around to no avail. I hope that makes sense! Thanks in advance The igniter is not working and should be replaced and there is also a problem with
Usually answered in minutes!
268 Questions
136 Questions
118 Questions
87 Questions
91 Questions