Questions & Answers for: GE burner knobs Pool & Spa

burner in the oven to blue flames on a GE propane gas range? how do I adjust the flame on a GE PGP - Instruction from GE says to adjust with a screw that is under the on-off knob === there is no screw

burner will not turn off Hello, i have a GE Spectra radiant range. when i turned on the rear larger burner on the left of the oven the small burner also went on even though i did not turn the knob on ...

...burner. Temperature control is fine for all burners. Everything else works fine. Thanks for your help. may be a problem with the switch itself, but honelstly dont take offense but make sure the knobs ...

...burner leaks even its control knobs is in off position (I can ignite that burner with a match without switch control knob to on position). I felt that the control knob is hard to turn, so I removed ...

...burner lights other burners will work but clicking wont stop clean the knob control by using vaccium,pull the knobs then clean it.make sure how to remove the knob,same position to returrn the ...

...burner. The contacts inside are stuck together. You will need to pull the unit and separate the glass from the lower body to access it. To get the right switch you need full model and serial number ...

burner igniter will not spark on any of the burners, but all the other control knobs work just fine for all four burners. I am guessing that the igniter module on the back of the stove is the problem.

turn as stated in manual. I have to turn the knob past "lite" before flame comes on. Is it just one burner knob that does that are all of them? If it is just one then the igniter switch built into the

The oval burner has only very low flame, even when set on high The oval burner knob(and operating instruction manual)specifiy a flame range exactly the same as the other burners: from "High to Low". ...

My GE Profile propane gas cook top was just installed yesterday. When I go to turn on one of the burners, all of the ignitors click. This can't possibly be normal. Anyone else have this issue? Yes, ...