Questions & Answers for: KitchenAid command pr Computers & Internet

control panel not accepting commands A pot boiled over on my kitchenaid electric range (kera807), but not all that much. Now, the control panel is asking us to set the temperature on the oven probe or

CONTROL PANEL WON'T WORK AND HAS - F2 E0 - ERROR stove top works fine and the whole control panel lites up and off and won't accept any commands Remove the power and disconnect all connectors to the ...

...de votre console, avec tous les noms et les numéros de partie, au cas où vous souhaitez commander des pièces de rechange pour fixer vous-même la table de mixage. Bonne chance. ...

...Control Locked" light is on. The Control Locked light is on and the washer will not respond to anhy command. We have tried to push any combination of buttons, lloked on the back of the machine for a ...

...cost will be involved. If it is the magnetron, depending upon where you purchase one from will command the price. Hope that

Water does not enter washer when set for hot water wash. Cold water flows freely into washer when set on warm or cold. Had repair man out to replace clutch gear about 15 washes ago Hi from retired ...

...to start up the main program controller must initiate the INLET/PUMP MOTOR/DRAIN to work when it is commanded .If this does not happen then the voltage at these points must be checked or the fault ...

oven won't shut off oven won't shut off It sounds like the control panel has a short in it for the off button.  I did some research on that particular model and it seems that this is ...

water. Make sure that a fault in any of the cycle will relate to the specified action, so check the command from the program module and then the executing device be it the valve or motor or pump. 

dishwasher will not turn on and control light blinking The command and control center may be damaged from a power surge or misuse. You need a new Powerboard.