Questions & Answers for: Cisco command switch Computers & Internet

switch. If you did login with the enable password, the command to run for CATos is "clear config all". For Cisco IOS, you have the right command with "write erase". When you issue that command, do you

...command line I have one switch and I can not move on to the privilege mode. when I power on i have only this : "Switch :" That is the expected behavior of the switch. If you want to go into privilege ...

...switch, we need to have a console cable connected in the console port and an image for 3560 on your system, Issue the command " copy xmodem: flash: " after this go to transfer file in the menu of ...

...command. switch: load_helper switch: 6>Issue the dir flash: command. Note: Make sure to type a colon ":" after the dir flash. 7>Type rename flash:config.text flash:config.old to rename the ...

...command "Enable" Switch# Enter the command "erase startup-config" It will prompt you to confirm When you confirm, it will bring you back to this prompt Switch# Now, enter the command "reload" It will ...

...command or computer name, or unable to find computer address. Actually this is happened after reloading. I have limited knowledge in this area, however if the switch is set to factory defaults, it ...

...Please do the below steps. 1. Log into the switch 2. Come to enable prompt 3. Typein the below commands config t config-register 0x2142 end write memory The find an example of the prompt and the ...

...switch could be looped. You could either unplug each rj45, or go into each port and use the shut command to find out if that is the case. If there are other switches hung off of this one, you could ...

...switch Enter the telnet access password for the Cisco swict when requested, and then the "Enter" key. Type "enable" at the command prompt, and then the "Enter" key. Enter the Privileged Exec password ...