Questions & Answers for: True e1 controller Home

Replacing a temp control valve on a true GDM 26 commercial refridgerator Hi, I have a True Model GDM 26, and I need to replace the temperature control valve. The plate with the control knob is on the ...

no power to compressor Probably the cold control (or thermostat ) is bad .Unplugged the unit and bypass the cold control by putting together the two wires and wrapping them with electrical tape . If ...

True GDM 12 won't go over 57 degrees. Just got it,older model no T-Stat. Cleaned up last night did see some brown syrup looking stuff.I did wait about 8 - 10 hours before pluging in. The unit has been

true cooler frezzing kegs of beer I have just started having a problem with my true cooler frezzing my kegs of beer whta temp should I dial it on to solve this prblem If I am not mistaken, the True ...

I have a true upright commercial display refrigerator.I think the tempature control is faulty.It freezez everything,I use it for beer and wine.I have cleaned the condensor and still no luck.No matter ...

I have a True GDM-26, that I determined had a bad temp control. I ordered a new control from a company the referenced the part number by unit model number. I did not take the original control to match

P-1 code is flashing on temperature display P1 is almost always a fault on the sensing (control) probe. Check it's end is not wet or covered in thick ice, and check the connections at the ...

How do I calibrate the temp. control on a GDM-23 that runs too cold 32-25? If you cant get the control warm enough there are a couple of possibilities. First:You recently had gas put in the system and

What is the standard defrost timer control setting Usually every 6 hours will keep the evaporator coil clear of frost. I set the time at 45 minutes per defrost. This unit has a defrost termination ...

...on units with Dixell electronic controls. "E1" . .. E1 is error code for air temp probe 1 has failed. Need to have it checked to be sure it a bad probe (sensor) or a bad connection/bad