Question about DDR2506 Dehumidifier
...E7 = Problem with Temperature Sensor I hope that helps. P1 is code for defrosting. Once it's done defrosting it should start operating normally again. If you get the error P1 it is because it is in ...
...code for my model. He also described other General Codes (applicable to most Dehumidifier/Humidifier models): E1 = Not enough water E2 = Not draining E3 = Water temperature too cool E4 = Overflow ...
...code for my model. He also described other General Codes (applicable to most Danby Dehumidifier/Humidifier models): E1 = Not enough water E2 = Not draining E3 = Water temperature too cool E4 = ...
...code for my model. He also described other General Codes (applicable to most Dehumidifier/Humidifier models): E1 = Not enough water E2 = Not draining E3 = Water temperature too cool E4 = Overflow ...
...E7 Error Code, indicates that the front cover of the unit it no properly in place and making contact with it's removal sensors. Remove and reinstall front cover properly. Be sure to turn the ...
...E7 TEMP SENSOR THERMOSTAT REPLACE ERROR CODES: DDW497W Problem Solution Error 1 Water supply is turned off Turn water supply on Detached / damaged pipe Replace / readjust pipe Low water pressure ...
Usually answered in minutes!
312 Questions
314 Questions
258 Questions
200 Questions
154 Questions
