Questions & Answers for: GE express cool Computers & Internet

...to a temperature. We change it to 37 and the set light goes out and the reading goes back to 72. Express chill feature works for bottom compartment. Seems to show some kind of error message which ...

...cool, 20 F freezer side and 44 F frig side is the lowest the temperature. Note: Express Thaw continues to stay ON, set to 3lb Changed setting to no selection, close door setting turns back to ON. ...

...XL MICROWAVE OVEN JVM1440 GE spacemaker xl microwave oven JVM1440 Two weeks ago after I press 6-express cook stopped and all the lights and clock went blank. In a 10-15 minutes it came back on

...section. I've found the temperature set to 37 but reading in the low 30's. None of the Turbo Cool, Express Chill or Thaw functions are on. turn the temp setting up to40 then check in a couple of ...

...express cool and it changed itself to express thaw.. I have tried to locate the dampers to observe if closed could not see. I would like the ability to run the self diagnostics but can not figure out ...

Express Thaw comes on when refrigerator door is closed Express Thaw comes on when refrigerator door closes. Freezer @ 23F Set @0 Refrigerator @ 42F Set @ 37 INSIDE DOOR LISTS THESE NUMBERS: PSC23NG ...

...GE Profile refrigerator/freezer had completely quit cooling. The problem seems to be in the "express thaw" feature. I could not get it to reset, but thanks to you, I reset it last night ...

Cool and it has come down to 16, but that Turbo engine is running. Express Thaw--the bottom light is on (3.0 pounds). I click through all of those Express Thaw buttons until no light is on, but when I

...and refrigerator stopped cooling. Electronics on and both setpoints set below normal temperature. Express chill gets fans going but no cooling. the compressor must be check it's either the

...Express thaw coming on & will not turn off. Help?! It doesn't cool Condenser coils Make sure you dust off the condenser coils to prevent dust build up and overheating due to it overworking. Simply ...