loading washers if your machine is more then 6 year old then it could be the 2 dampers at the base of the machine has worn out. If the tube wobble too much the machine would not go into fast spin. Its
Question about Elite 45986 Front Load Washer
...load is finished. When I put a load in, it goes through all the cycles just fine until the final fast spin. It doesn't do that any more. It just beeps that it's finished. Last night it was running ...
Question about 22422 Top Load Washer
would cause my washer not to do a final high speed spin? Leaves the clothes quite wet. It does spin fast during rince cycles and g the final spin cycle but will not go into the very fast spin required
...loading washer... Maybe 2 years old, and the other day I put a load of towels in that were soaked from a huge leak... Maybe 9 towels and a small bathroom rug. Well, when it came time to spin, It was ...
the water drains too fast and overflows When the water starts to drain during the spin cycle the water overflows out the drain pipe. Is it draining too fast or is it all in the drain? It doesn't ...
...goes to spin the motor sounds like starts n stops starts n stops Check your speed selector switch (fast/slow, fast/fast, normal/fast etc.)first and foremost! Make sure it not set in-between speeds. ...
...loading washer model 42162....no longer going to final "fast spin" leaving clothes full of water. Belt had fallen off but even when replaced the machine is not going to fast spin Make sure all the ...
Question about HE2 Plus Front Load Washer
OK- my Kenmore He2 won't spin fast enough to drain when there is a heavy load involved. This is what I've done- emptied the filter- lots of change and other gunk, cleaned out attached hoses and the p ...
Kenmore 417.43142200 final spin is slow Cloths are still wet after washing cycle - won't do a fast final spin. Pump works fine. I cleaned contacts on the timer and it worked fine for 6 months then
won't spin fast when fully loaded on spin cycle, won't spin fast unless some clothes are removed. works fine with light load You may have a weak clutch. If you can stop the washer during spin by hand,
Usually answered in minutes!
19,136 Questions
12,215 Questions
7,310 Questions
7,276 Questions
5,470 Questions