Questions & Answers for: float assembly Dehumidifiers

...assembly (sometimes this is very obvious inside the case, often a car spade type fuse which is worth checking visually), and there are cut-outs that will stop the compressor if it is low on gas, ...

float assembly and it to moves OK. Any solution? I have the same problem! Can't figure out what's wrong, and don't want to take it back... probably a bad switch at the float assembly...check that out.

...assembly" for your model and change it out. It consists of Temp/humidy sensor in coil, temp sensor in suction return line, and plug harness that goes to float switch. My uni is running like new

...assembly that has the float valve in it, rather than the tray. In any event, there are not many parts still available for this unit, as it has been discontinued by Fedders. However, they did make the ...

float assembly with your finger to see if you can loosen or dislodge it. Make sure the unit is set to MAXIMUM so it will turn on right away if you manage to fix it that way. If this works, then try to

...float valve or a new bucket assembly, the best place I've found is online is Appliance Factory Parts http://www.appliancefactoryparts.com/search/index.php they carry parts for just about any ...

...float valve, that sits inside the (I believe) the top right side of the bucket. It shuts the unit OFF automatically, when the bucket is full. Hopefully, it just fell off and didn't break off. The ...

...float assembly? Unfortunately, the entire float assembly (Part # CRCDFD5404-010) is no longer available and their are no interchangeable substitutions.In lieu of that, if you can hook it up to a hose ...

be careful doing it. Also, make sure the float valve's shaft/arm is not broken off. If it is, you will need to replace the entire float valve assembly. Hope this helps and thank for choosing FixYa

How do you assemble a float switch on a Kenmore model #25506 dehumidifier that accidently came apart. you find a new part and install it