Questions & Answers for: Zebra form alignment Computers & Internet

Eltron P210i printhead replacement and aligment I changed the printhead but I hae this white space all in the top f the card and don't know how to align. In all series I had a PTOOL software from ...

...any help. If you print a power on test label, see if the print is aligned, id so, use the top of form setttings to get all the print on the label. As far as a USB, the printer will only take ...

...alignment problems with this printer. The first label prints fine but each label following will get a little misaligned until they finally have a label that does not print properly. Also, they find ...

...then a constant red light comes on the feed button. If you are using a ribbon remove it and perform a calibration, hold down feed key for 2 seconds as you power on, release key and wait for it

...alignment issue. The problem is when I send a label print job to the Zebra printer. It starts printing so low on the form and then prints the rest on the 2nd form. It should fit on one form. However ...