Questions & Answers for: Lexmark fuser assembly Computers & Internet

Question about Optra SC 1275 Laser Printer

1 Answer

...fuser assembly and noticed a couple of streaks/spots on the orange colored drums. Could this be the problem ? any ideas anybody..... Thanks to John A., I appreciate your responses based on your ...

Ad

Question about C760 Laser Printer

1 Answer

...fuser assembly Remove the rear cover Remove the fuser top duct screw and disconnect tab Remove the top duct Remove the redrive belt cover duct Remove fuser left duct Remove fuser bottom duct Swing ...

Ad

...Fuser Assembly Removal 1. Tilt the printer carefully to the rear so it is resting on the ASF. 2. Remove the four bottom cover screws. 3. Disconnect J7 (THM) from engine card. 4. Reattach bottom cover ...

Question about C510 Laser Printer

1 Answer

...Fuser Assembly Fuser Drive Motor Fuser Motor/Paper Feed Motor Carriage Unit Motor Cable Engine Board Check the fuser assembly internal drive gears for binding, or broken or worn teeth. If a problem ...

Question about T430 Laser Printer

1 Answer

...either disassembling the fuser and replacing the thermistor ( if you can find one) or replacing the fuser assembly. so i would suggest that take it to nearest service centre of lexmark. best of ...

...actual fuser assembly. unfortunately you can't just remove/clear the error. see picture attached as this is what the fuser looks like after you replace it let me know if you still receive the

Question about C543dn 26B0000 Workgroup Up to 21 ppm 1200 x 1200 dpi Color Laser Printer

1 Answer

Fuser assembly, 115 V 40X5438 Fuser assembly, 230 V 40X5439 Fuser assembly 100 V Replacing the fuser is not very difficult but you will have to follow certain steps. 1. Remove the right cover assembly

Question about X342n All-In-One Laser Printer

1 Answer

...fuser assembly or redrive assembly. Feed a sheet of paper, and if the same error occurs after clearing the fuser or the same error occurs when no media is present, check the exit sensor assembly. For ...

Question about C530dn Laser Printer

1 Answer

...properly. For this error on this Lexmark model ... You have to replace your fuser assembly. (Assembly 115V fuser) (40X3569) I suggest you contact Lexmark Technical Support for further

Question about W840 Printer

1 Answer

...Does the fuser cooling fan RPM increase? If yes, perform a print test, and if the error continue, replace the printer engine card assembly. If no, check the fuser cooling fan for proper

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...