...to suit media you are printing on ie card. If this is the case fuser runs at wrong temp an fails to apply enough heat to fuse/melt the toner into the paper and fuser rollers gunk up. read users ...
...fuser and chaces are this most likely will resolve your problem Ii may be that you have poor sensor flaper response, somewheare between paper pick up section and fuse unit. Check the paper ...
...to the fuser,remove the fuser and see if there is something wrong in it Fuser error earor 980 mines fuse earror u need to chanege your fuse to change your fuse u need to go with a good printer ...
Question about KIT-C3530N MFP LASER CLR P/S/C/F USB ENET 1200X600 128MB Printer
...fuse cutting of fuser Is the fuser installed correctly? Does the error recur? Yes Reinstall the fuser after its connection connector is cleaned Turn on the power supply again If error still exists_ ...
Question about KIT-C3530N MFP LASER CLR P/S/C/F USB ENET 1200X600 128MB Printer
...fuse cutting of fuser Is the fuser installed correctly? Does the error recur? Reinstall the fuser after its connection connector is cleaned if error still exists- Turn on the power supply again ...
Question about C5100n Laser Printer
fuse, these machine have a FUSER that needs to be changed, it is the hot bit at rear, after the four toner and drums, two locks right and left, lift black unit at rear out, replace unit called a FUSER
...replace the little fuse. Easiest done in belt and fuser. Almost impossible in drums. Or one might construct a little device with a fake fuse to insert between the part and the corresponding
...temp error The fuser is not heating up to fuse your toner to the paper. You may have had a bad paper jam that damaged something? Make sure there is no torn paper at fusing unit that has been
fuser, transfer belt) into the printer, that main board resets the counters AND THEN it immediately blows a fuse (not a regular fuse, but a microchip fuse) in that comsumable so it can never reset the
Question about C3400n Laser Printer
fuse on the fuser unit or you can do the option below that I DO NOT RECOMMEND separate the fuser unit in half Unravel and loosen the wires at the connector at the bottom of the fuser close to the edge
Usually answered in minutes!
1 Questions
2 Questions
2 Questions
1 Questions
