Questions & Answers for: Sharp where is the fuser located Computers & Internet

Question about AR-C270 Color Copier

3 Answers

...write correct code h5-01 code means ther has been 5 consecutive jams in the same location...the fuser. the copier locks out for safety reasons. you will need to access the engineer codes to reset ...

Ad

...located in the fuser unit, will need replacing. Cheers Andy :) Mark, yes L4 is main motor, do the reset again. If L4 reappears i still think you have fuser issues. Being very careful not to ...

Ad

Question about AR-BC260 Color Copier

1 Answer

...fuser unit by unscrewing the large green wheel located under the frame on the left side door below the fuser unit. Lift the fuser unit using the handles front and rear sides. (be careful it is very ...

Question about AR-275 Copier

1 Answer

...there is a sensor on the exit end of the fuser on the right and the flag for this is located in the middle of the exit guide on the fuser this gives us most of those types of jams. Hope that

Question about AR-275 Copier

1 Answer

...code. What does it mean? The fuser has a problem. With that model most likely it will need a fuser lamp replaced, sometimes it can be the thermo fuse located on the fuser. Hope that helps... ...

Question about AR-5316 Advanced Digital Imager Copier

1 Answer

...fuser is located. Try to feel the area and see if it is warm, careful not to touch the heat roll itself, it can be hot. If it is not hot, the problem area is with the unit, or the main board that ...

...the roller. You can do the following; Remove the power cable. Open the covers so you can access the fuser (the hot part) Look inside, you will be looking for about 4-6 scrapers, they should look like ...

Question about SF 2020 Copier

3 Answers

fuser rolls located on a sharp sf-2022 copier Clear Drum Sharp AR 5520 If I remember correctly the drum is at the front in the middle, maybe behind a plastic cover? It pulls out towards you. The fuser

Question about AR-M700N Copier

1 Answer

Sharp AR-M700N damaging fuser rollers. I just replaced both rollers, Upper and lower, the cleaning rollers as well and when I installed on the machine it bacame so hot it rip off the skin of the lower

Question about AR-M700N Copier

1 Answer

fuser located on MXC 311 Where is the fuser located in the printer/copier. There is a loud noise Hi, The fuser unit is located in the right hand side of the machine. If you open the right door, inside

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...