Questions & Answers for: Jeep hex codes Computers & Internet

...- tighten band adj. screw to 72 inch pounds, back off 3 turns + The 47RH rear band requires a 1/4" hex driver, the front band requires a T-30 Torx driver, the filter is held in place by two screws ...

...but here is information from the 1998 Jeep Grand Cherokee Service Manual, ezg_25.pdf, page 6 of 20? Hex Code = 95 Generic Scan Tool Code = P0462 DRB Scan Tool Display = Fuel Level Sending Unit Volts ...

Hex code 43 is for a misfire. DTC 43 indicates a cylinder misfire, but does not specify which cylinder is misfiring. To pinpoint which cylinder is misfiring, you need a scan tool and get the "P" code,

hex head bolts. Here's a URL to see what it looks like: http://www.google.com/imgres?imgurl=http://www.jeepz.com/forum/attachments/cherokee-commander-wagoneer-liberty/2461d1239837264-02-grand-cherokee

...- Location is located: Transmission / Transfer case Is locates on the transmission it has a 1" hex head and screws into the transmission, the output speed sensor referred to in the code only ...

codes. (ask) a cheap $25 cant do that. according to alldata.com the car does have it, so? here is the TSB last line , on topic Please be aware that if the Wireless ControlModule (WCM) is replaced, the

...hex codes. DRB shows. so my point, is this, yes any tool could read it, and most don't but in life, there are always exceptions, and the below is 1. Some newer scan tools can do this. but will cost ...

..."no cam shaft sync signals", CMP. (1996/7) CMP = Cam position sensor. (or CMP is misfiring) (9D-hex? factory DRB? scan tool) ( or OBD DTC P1391) CMP/CKP loss. (1998+ code) the book covers this , ...