Questions & Answers for: Tally motion sensor Home

...sensor option paper out and paper motion user/maint calibration procedure paper motion fault, what can cuse it are as follows 1. motion belt 2. hammer bank belt 3. check the hammer assy. This info is ...

...motion sensor faulty the problem is with sensor calibration,activate the TECH-ASSES mode pressing ENTER + LF switch simonteniously,than calibrate the paper motion . upadhyay girish go to ...

...is full. How do i clear this error???? You lost the sensor calibrations. Grab the service manual. Do the four fault clear, enable tech access mode and calibrate paper motion, paper out and

platen motion fault in tally genicom 6312 problem with platen sensor , clean the sensor with ipa still same problem change the platen sensor

tally 6050 shows paper motion fault paper movement problem.pls check the paper movement is proper or not and check the paper motion sensor it was lie in the LHS sprocket

...you need to clean paper motion sensor first,check its connection on logic board clean the connector of sensor,if you can then please post u r problems with printer model then i can explain it

...Sensor on its own, you can only over ride all faults this may cause other problems as Paper Out, Paper Motion errors are also overridden. You can enable fault override in the following way; Press and ...

...KEYS to turn tech access off, you can then test the printer. If the above does not clear the message try increasing the value further.If the problem persits you may have a faulty paper motion

...motion sensor ? Press the LINE FEED and ENTER buttons for five seconds until the printer flashes up TECH ACCESS on Then access the menus as described below. Press the MENU buttonPress the DOWN ARROW ...