Questions & Answers for: Intermatic nc Heating & Cooling

... and black instead of to power supply and to load. the timer itself has a connection for the timer, NC, NO,COM,NC2, NO2, AND COM2. SO where does the white go and where does the black go? I know the ...

out. The timer has internal switches that you connect the input and output to . That is the NO, C , NC set of contacts. It also has a set of terminals for the clock, usually the first terminals on the

...T1905 has 4 screws: NO normally open > NC normally closed > COM > Clock NO screw is on left NC screw is 2nd from left COM is 2nd

...T1906 is 240V timer with 240V clock motor There are 4 terminals: NO NC COM Clock NO terminal (normally open) turns ON when the timer turns on NC terminal (normally ...

...cycle each 5 hour period. This timer has 120Volt clock motor and is 120V timer. Timer has NO and NC terminals. NO terminal turns ON when timer turns ON NC terminals is ON all the time, except when ...

...hot wire to Load connects to NO normally open terminal. This terminal turns ON when timer turns ON. NC terminal is ON at all times, EXCEPT when timer turns ON, and then NC terminal turns OFF Your ...

...120Volt 30-minute cycle timer, which repeats same timing cycle every 30 minutes. Timer has NO and NC terminals. You will not use the NC normally closed terminal for this application, so no wire

...separately by the timer to control 8 different electric circuits. This is called 8-channel timer since all eight timing contactors can be programmed separately. Each contactor is wired separately to ...

...a two speed motor T104 cannot be easily set up to handle 2-speed motors You need T106 timer with NO NC terminals. Or you can use the T104 to control relay with NO NC terminals... relay would need 240 ...

...says clock and neutral line from breaker connects to it. Two other connections are for NO and NC. I want to connect my sprinkler valve solenoid that has two wires. Which of these four connector ...