...Open the Left side door and remove the fuser unit by unscrewing the large green wheel located under the frame on the left side door below the fuser unit. Lift the fuser unit using the handles front ...
sharp arc 262 paper jam at fuser unit Turn off machine, open drawer where fuser unit is and gently pull out the jammed paper. You may have to replace the fuser unit.
fuser from the front after removing the 2 phillips screws. Left door needs to be open also. On the bottom of fuser is a small push button that may have tripped. Push to reset. Reassemble and try again
...open up the right-side door the fuser is the black box-like unit. It has small tabs that allow you to open the access hatch to look inside at the rollers. Unfortunately the sensors are behind the ...
...open the fuser gate with all the teeth on it. This will release most of the fusing pressure. Gently pull the paper backwards out of the machine. About the bottom 1/2 of the page will have NOT gone ...
...fuser unit:Locate the rear door and open it. The rear door opens and drops down towards you.Look into the back of the printer. See if there is any paper or any other item stuck there that could be ...
...install fuser in mx 2300n Hi Open door on right, should be to blue screws holding the fuser unit in, remove the screws, then pull out fuser using the grey handles at either end of the ...
fuser. Open door on right, three screws hold the fuser in (hot bit), release fuser slightly, being careful as it is still connected, the thermistor is sat in the top, you should be able to reset it by
...fuser unit is located in the right hand side of the machine. If you open the right door, inside the upperpart of the machine you will see 2 grey handles, 1 towards the front of the machine, the other ...
Usually answered in minutes!
1,105 Questions
603 Questions
559 Questions
331 Questions
354 Questions
