Questions & Answers for: remove shell Vacuums

...remove inner shell. I tried to take my switch out and gave up after several attempts at pinching the plastic tabs inward that hold it to the case. even with all four tabs pushed in the switch didnt ...

...Remove those two screws and then you can proceed as mentioned above. When reassembling the head, if the shell does not snap back onto the base, check for plastic chips or other debris in the narrow ...

...shell to get to the switch. you remove the screw up front and the 2 scews buy the the rewheels from the bottom and then you pry the shell apart from the gasket it is tight but once you get it to ...

...Remove the ball shell to inspect it looking for cracks, check the bearing and the area the ball shell connects to the vacuum to try to find the cause. The ball was not rolling but when I checked the ...

...shell screws. Remove the four screws holding the upper motor shell in place to expose the fan housing screws. Remove the five screws holding the fan housing in place, noting their positions. Pry the ...

shell are 1" Torx...you don't have to remove them, but it's handy to know that all the screws on the outer shell are interchangeable, except the 3 that hold the shell together. In addition, there is a

...remove the ball shell without dismantling the entire chassis? Hi there, it's Jack at Dyson. The issue you've described sounds very unusual. Both halves of the ball shell include bearings, and should ...

...it from opening completely enough to remove the filter but we cannot tell where the problem lies Spin the center cap of the ball Counterclockwise to remove the ball shell to gain access to the

...DC41 The ball shell screws on the bolt sticking out of the side of the vacuum. Remove the little cover and twist the ball shell back on the bolt. Sometimes he bolt breaks off and needs to be

...remove the ball shell on that side you will need to turn the small round center cap counter clockwise. I usually stick two small Torx screwdrivers into two of the holes to give some leverage to turn ...