Questions & Answers for: Panasonic how to replace an ic chip Computers & Internet

replace it? if you can remove the rear panel assy. look for the convergence ic's they start with stk--- and you got the part number you need a source panasonic is 814 source and the number on the ic's

Replaced IC chips and fried something Hey guys, I replaced the IC chips on my PT 53W53G and I fried a couple of resistors, Must have melted or crossed something. IS it worth getting this fixed? Can ...

...replace for the chip upgrade which I plan to do. Hopefully it will go well if I put the chips in either location. Thanks, I have the panasonic ptv47 projection set and ordered the sanyo stk394-160 ...

...replace IC chips in a Panasonic PT-53TW53 projection tv Its failure of 2 convergence out ICs and requires replacement. You can replace these ICs if you have basic electronics knowledge and good ...

...replace them also---this set uses two STK-392-110 convergence IC chips---you will have to remove the light box---I can tell you how--look for the convergence ic's inside and take a close look at the ...

...replace the IC chips and adjust the set---I have done hundreds of these sets---3 blinks is almost always a bad convergence IC--if this was helpful give me a vote---AND IF YOU NEED DIRECT ASSISTANCE ...

...replace ic chips on Panasonic 52 inch hdtv projection? Most IC's on circuit boards these days are of the surface mount variety. You will need special Desoldering Equipment to remove these chips, ...

replace. Thanks Steve Hi, There are two big black ICs that will be replaced. Number would be written as STK392-110 and available with Part Store. Click above link to see an image of that IC for better

...chip with a #TUC2AJ045 on top of them. I wonder if they are the chips i need to replace. Thanks Steve You need 2 STK392-110 Convergence ICs and possibly 6 2.2 ohm 2watt resistors. You can get the ...

...replace horizontal output ic. Did so. Still having the same problem. Three blinks is short protection. 97% of the time it means one or more of the 2.2 ohm blue resistors around the two convergence ...