Questions & Answers for: Philips how to replace an ic chip Computers & Internet

Question about 60PP9202 60" Rear Projection HDTV-Ready Television

2 Answers

...IC's (2) and I would replace the 12 resistors. I got the convergence amps from www.electronix.com for $10 each, plus a couple bucks for some heat sink compound. I also purchased a good quality solder ...

Ad

Question about Magnavox 9P6034C 60" Rear Projection Television

1 Answer

...9P6034C 60... no picture, or small picture, what are the chips that need to be replaced? You need to replace an IC chip on the main power supply board. You can find instructions on ...

Ad

Question about 60PP9352 60" Rear Projection Television

1 Answer

...ic chip and some transistors. I'm not sure if I should just do the Chip, or the transistors, or both. Or maybe I should try the chip first? Also, do you know the location of the transistors. I would ...

Question about Magnavox 9P6034C 60" Rear Projection Television

1 Answer

...chip the picture started having an upward bow at the center bottom and downward bow top center. Recently had same issue and after EXTENSIVE SEARCHING found all three ICs and replaced them. TV works ...

Question about 46PP9302 46" Rear Projection Television

1 Answer

move parts around or is it all digital? Should I take the board out again and just resolder everything- what one if the IC's controlls the red? so I can just check that chip. You may have bad IC chips

Question about 43P8341 43" Rear Projection Television

1 Answer

...size or less. they are easy to find as all of them are in pairs. if you find one is not the same on the other, then replace that resistor. change the 2 convergence IC at the same time. let us

Question about Magnavox 27MS343S 27" TV

2 Answers

...IC chip is dead. Problem could be in the jungle IC - affecting the line drive stage somewhat. I would check all components around this IC as well as replacing the chip since they may have changed ...

Question about 60PP9202 60" Rear Projection HDTV-Ready Television

1 Answer

IC chips burnt out. You will need to replace them. A good place to purchase high quality IC chips is convergencechips.com.Be careful there are a lot of fakes out there that don't last and cost you

Question about 60PP9202 60" Rear Projection HDTV-Ready Television

1 Answer

Phillips Magnavox 9P5534C103 need to replace Ics How to replace the Ics on a Phillips Magnavox 9P5534C103. Picture will Shrink and have curves. Green color is blurry Check with TV repair.com who sells

Question about 60PP9202 60" Rear Projection HDTV-Ready Television

1 Answer

saw that some heat sink was touching a couple of them, is it bad? Shall i buy new ICs? After the IC replacement, convergence adjustments should be done. If you wish to get some details; visit the site

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...