Questions & Answers for: replace ntc Dehumidifiers

Where, in the UK, can I obtain Amcor replacement parts? Re: Amcor HD 320 Dehumidifier Serial # 016734 When powered up, the compressor on my Amcor HD 320 dehumidifier is constantly switched on and off ...

...to side if there?s any play in the shaft side to side then the bearings are worn and motor needs replaced. Then, check the capacitor, if it?s bulging even slightly, the capacitor is bad and needs ...

...fixed instead of a new unit This is NOT a member of the family. The sealed system repair cost (to replace the evaporator) would exceed the price of a replacement dehumidifier. (even if it is in ...

...for my holmes dehumidifier anyone know where i can find one? is it worth replacing or should i just replace the whole unit? mcdevito75 here, See what they say online at Holmes Dehumidifier .com, may ...

NEED THE RUBBER PIECE FOR WATER DRANIAGE; A PLASTIC CONNECTER TO THE SCREW ON WATER EXIT HOSE FITS INTO A SOFT RUBBER INLET PORT; THE SOFT RUBBER INLET COVER HAS MELTED. I NEED A REPLACEMENT PART ...

I just replaced the thermal fuse as described by several of your people for a fan motor on a Kenmore dihumidifier 580.54701400. The unit ran fine for about an hour and then stopped with a burning ...

...DIY fix for Duracraft TEC10E E2 error, in case it's useful for others: (When I tried to get a replacement temperature sensor via UK/Ireland support (kaz.com -> www.hot-europe.com) I was told ...

how to locate and replace internal filter?? For frigidaire Lost manual for model #LAD304NUL Good Afternoon Friend, I understand that you are trying to locate and replace the internal filter for your ...

...Replace the electric control Error 6 NTC thermistor damaged/out of position Replace or readjust the thermistor Temperature is too low Temperature should be above -20? Damaged or defective wiring ...

i have an ebac 2850e dehumidifier,the fan stopped working on inspection of the wiring i found the sensor had burnt out am I right in thinking it is a ntc thermistor, and if so what value would ineed ...