Questions & Answers for: Protocol reset crashing Computers & Internet

it keeps crashing as soon as i lift off the ground it banks hard to the side and crash's i can't control it at all. use the controller change the setting to the L and R dont setup in the air make it ...

Trim problem. Won't hover ,just crash How do you know what to trim when it's justcrashing Try to operate while holding it... Or have someone else holding it, if you can feel where it's want to go ...

My helicopters tail bends down just a little, starting just past where the support beams and tail connect. I can not remember if it came like that, and I have not crashed really bad, it flies ...

manta 4 channel rc quad-copter will not calibrate properly Continuously will try to flip in one direction so will not hover- as if the stunt button was active - adjusting will not effect this. It is ...

why wont my raider blades turn. Battery is charged lights go on but will not do anything from the remote Check to see if the motor turns by hand. Reset the remote to the current channel on device.

how do you reset the remote to the current channel on the device? Instruction manual/book should cover that subject.

I hava a protocol-predator sb, after several crashes during practice flights: the rear rotor is no longer working. there is a loose black wire on the circuit board thas came loose on on end but i cant

...crashing down to the floor. I've never had any bad crashes, and it hasn't been doing this before. Maybe the internal gyroscopes are not calibrated right? If so, how do I reset them? I don't want to ...