Questions & Answers for: Intel setting bios Computers & Internet

...F9 , it configure with default setting, this command press in all the bios configuration. 2 check with the idu bus,& any pin is broken,R change the IDU bus. 3check in main broad change the idu

msi MS-6741 bios not save the settings Hi, My Board version is MS-6741 ver:1. I am facing one problem is , my bios is not saving the changes . If it is not power off it will work. once i switched off ...

unable to boot boot settings are disabled in bios and unable to enter into bios i have intel D101 motherboard and 2.8GHz processor, 512MB Ram but boot settings are disabled in bios and unable to enter

...This error is not the same as a CMOS Checksum Error, which refers to corrupted values of the CMOS settings, the ones you set through the BIOS setup ... When computer on tap the del buuton to get in ...

...in graphics from 2GB of RAM. How is it Possible? Please help me. it can only be done in the bios settings. but you cannot get 128 mb. normally the onboard sharing will be set a max to only 8,or 16 ...

...i have ECS 945GCT-M2/1333 mobo and i am trying to overclock it through bios but all overclocking settings grayed out ... so is there a bios update or any modified bios for this mobo to unlock ...

...Setting the "BIOS Configuration Jumper". Read through it carefully & perform the described procedure setting the jumper to the "Configure" mode. This will enable you to reset your BIOS

...bios setting nd ur computer work properly its of bios setting problem remove the cmos battery nd left for 2-3 hours with no power then power on the system in other case ur computer does not further ...

what is bios password A bios password protects access to Bios settings. BIOS: Stands for Basic Input/Output System. The BIOS gives the computer a little built-in starter kit to run the rest of ...

...BIOS setting with setting like 'disable error' or anything else like that. But might be better to check what happened to your BIOS. For example if you dont have Floppy drives then set in BIOS ...