Questions & Answers for: Polycom sip setting Computers & Internet

setting for SIP or VOIP. If any of these do exist, make sure they are turned off as these may only confuse or adversely affect many implementations. If you are using autoconfig make sure that the file

...setting before... configurations for ringtones are set at user specific configurations or User Settings and uploaded to the configuration server. check that out too hope this helps all the best tc ...

polycom ip501f error, application is not present Make sure you have the latest BootROM and SIP config files for this polycom(sip.ld, sip.cfg, etc...) on your TFTP server. If you do not have this - ...

the ip phone cable and reset the ip phone all setting What system is the phone on? In essence, SIP phones are a single line station, so this may lie in the programming of the system it is installed on

sip, i configured that one but it display the message is failed to get boot parameters via DHCP, please give me solution. You didn't provide any information about your network which is ALWAYS required

have a dial tone but cannot ring out or receive calls It seems that you have set it to silent ring to change this go to menu --> settings --> basic --> ringtype --> and select low trill or

I have purchased 6 Polycom 330 SIP phones. I am attempting to get these setup with a hosted VOIP provider. 1 of the phones works fine. 1 further is unlocked on the boot menu so i think i will be able ...

...make teh call I'm assuming you already have a voip account set up. sounds like you've not set the dtmf tones to the correct setting, usually set to rfc2833 and/or sip info - set in audio to

...for my office? Please help Yikes man. The Polycom phones are used in just about every hosted or sip based pbx. So hard to answer without more information. Do you have a message or voicemail

......