Questions & Answers for: Light time delay module Computers & Internet

Question about Outboard Motor Boat Bass Fishing Saltwater Base

1 Answer

...module. Still, the coil could be tested with a continuity/VOM tester, same with the pulser. In some instances, it could just be the wire connected to the engine ON/OFF. If there is spark, then we go ...

Ad

Question about Outboard Motor Boat Bass Fishing Saltwater Base

3 Answers

I have a 1984 35 hp Mercury outboard that will start but spit and sputter and run for aboout 10-15 seconds then die. I've already rebuilt the carb and added fuel treatment to the tank. Anyone with any

Ad

Question about Outboard Motor Boat Bass Fishing Saltwater Base

1 Answer

thing i keep the old ones onboard. check you plug wires too. the omc are put together style and sometimes will vibrate apart at the ends

Question about Outboard Motor Boat Bass Fishing Saltwater Base

1 Answer

1985 40hp evinrude only runs at half speed it might be as simple as a dirty carb , but also might be in the ignition ,like a bad power supply module . check for spark on but plugs . check the carb/s ...

Question about Outboard Motor Boat Bass Fishing Saltwater Base

1 Answer

Shift Assist Module, OMC, 987571. Shift Assist Module, OMC, 987571. Need instructions for using this. thank you The omc module is a plug and play device. If you tell me what specifically what you need

Question about Outboard Motor Boat Bass Fishing Saltwater Base

1 Answer

Shift Assist Module, OMC, 987571. instructions for Shift Assist Module, OMC, 987571. instructions for use of this item You can post your question at this link ...

Question about Outboard Motor Boat Bass Fishing Saltwater Base

0 Answer

timing on honda BL100 How do you set the time on a Honda Bl100 10hp boat motor? you don't, timing is fixed by the flywheel.

...time always ran good.pulled four spark plugs and it ran? Cleaned them with either and started for a couple minutes then died again. It pops and almost wants to start but fouls out. Is there a module ...

battery is charging , but discharge light stays on,what is causing false indication? time delay control module, discharge control? JIM new batt. Too low load voltage , voltage must be 14 -15 volt

Question about Outboard Motor Boat Bass Fishing Saltwater Base

1 Answer

The spark to light the gas rings won't stop sparking, I'm frightened. Disconnect it from the mains for 10 minutes. If it is the type with a button, spray it with electrical contact cleaner. If it has ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...