Questions & Answers for: Mantis worms Computers & Internet

Tine shaft removal for mantis 2 cycle tiller I need to remove the tine shaft for a 2 cycle mantis tiller to replace the bearings and shaft seals. I tried to press it out after removing the bearing ...

mantis tiller blades they have lost the power move very slow Common problem with these small tillers. The gear box needs replaced or repaired. But first try removing the muffler and see if it helps ...

Mantis 2 cycle - tines lose power. My Mantis 2 cycle tiller is only three years old and has been used lightly. Yesterday, I worked most of the day in the garden. After taking a break and restarting ...

Worm gear has a hard spot, and doesn't turn freely. Tines will run for a short period of time and then stop. You will probably need to replace the worm gear and any other worn parts in the gearbox

are the tiller tines supposed to turn while the tiller is not on no the worm gear is not designed to

Mantis tiller 4 cycle engine runs but tines won't turn I pulled the engine case off as shown in the manual and the shaft was seated properly. I tried to rotate the shaft by hand and it would not ...

replace the roller bearing on mantisworm shaft I posted this same procedure in a reply to this post: http://www.fixya.com/support/t2127031-tine_shaft_removal_mantis_2_cycle_tiller Follow the procedure

The gears have locked up what is the problelm The tines do not turn Is the motor running and increasing power with movement of the throttle lever? If so then something is possibly caught in the worm ...

engine runs tines dont 2 cycle mantis tiller The following was extracted from the Mantis owners manual.. At some point, you may find that the tines won't turn when you press the throttle. This may ...