Questions & Answers for: Brother wrong tray Computers & Internet

...size paper is in that tray. Otherwise your paper settings in the paper meny are wrong as this can override the paper tray settings, check them to make sure they match the paper size in the trays

...tray. I encounter that problem before, after I checked the sensors, feed unit and mechanism nothing is wrong or broken but still NO PAPER indicates on the display .I only noticed with the machine is ...

Nothing appears to be wrong but this noise that comes from the left side of the tray drawer. If this is brand new, then it should be under warranty. Call the manufacturer or take it back to the store

...wrong with it? Gears on the tray is broken, or the gears that lift the tray. (thus the clicking noise). And the no paper is due to the actuators underneath not being activated because of the non

39;t get your paper. Push it to the unlocked position. Now try to print. I think the problem happens if you push the tray in too roughly and the button gets pushed into the wrong position accidentally

...wrong? It may have paper dust or little bits of paper inside causing this. It can also be a bad paper sensor or a worn paper tray. Usually its dust or a small sliver or paper. What you need to do is ...

I keep on getting a wrong paper size error and I just added paper to both trays and didn't change anything. I keep getting wrong paper size when I try to print to A4

...wrong tray selected when you print from your app. Also pull out all the trays and make sure you do not have a paper jam that you can not see. Sometimes paper jams will display as out of paper ...

...wrong and cannot find one. I pushed the go button several times and finally just the red paper light is on. I have played with the paper loading (more/less differentloadings/etc.) and the red light ...

...tray to slide out easier or am i just doing it wrong? did it ever get pulled out before because it could be that it was inserted wrong or if it wasn't pulled out it could be that the tray is stuck ...