Questions & Answers for: Canon wrong tray Computers & Internet

...wrong with printer, solution I found was to slightly lift the rear of the tray as it fed in, as it appeared to hit something on way in when fed by itself I finally got the printer to work by manually ...

...into the lower tray to print CD's . I don't see how it attaches! I could be wrong, but looking at all the specs on your printer I see nothing to indicate it is made to print directly to a disc. ...

tray in. How does this work or what am I doing wrong?? Those links might solve your problem: http://damnprinter.com/105/the-five-easy-steps.html http://damnprinter.com/176/tray-rejection-general-guide

...tray then something is wrong with the sensors or sensor area that tray 1 sits in... sometimes sensors arms get jammed or they break... if the issue is the tray then you need to pull out tray 2 and ...

...tray always shows empty. Even full of paper . This happens on both trays. Copier works with the side feed. check pick up assembly,maybe there is something wrong in the mechanical area of that ...

tray size is not programmed properly. This is also why the print is the wrong direction on the page. So the copier thinks it has 8.5X11 loaded like this > -- and instead it is loaded like this >

...says that you have to load the rear paper tray. There is no rear paper tray, it is underneath. What can I do? Seems like you have the wrong software for the device. Try uninstalling and

...the short way.. LTR or you may have the paper tray set for LTR-R and you have the paper in the tray as LTR. I believe that the paper trays are set wrong. You may have figured it out already.. Good ...

...wrong? First of all select the paper select button for the bypass tray on the control panel after putting envelopes in the tray. It will then say select paper size. Press the RIGHT arrow until COM 10 ...

...tray which is stopping the paper lift mechanism from functioning properly. The paper senso rcould be dirty or broken and will need to be serviced. Or, the papersize dial could be set to the wrong ...