3
Nater13 posted an answer for this Whirlpool Washing Machines:
"Replace the shaft and bearings... W10435302"
Nater13Nater13 posted an answer for this Whirlpool Washing Machines:
"See if there is 120VAC at the drive motor while the machine should be agitating... if you..."
Nater13Nater13 posted an answer for this Whirlpool Washing Machines:
"Inspect the spin clutch..."
Nater13Nater13 posted an answer for this Whirlpool Washing Machines:
"Water level pressure switch tube or air-dome may be clogged..."
Nater13Nater13 posted an answer for this Whirlpool Washing Machines:
"You have one of the best washers ever made... It is called a "Direct Drive" by us..."
Nater13
Nater13 posted an answer for this Whirlpool Duet GHW9150P Front Load Washer:
"No, NO, and No. Call a technician and expect to pay $500 bucks to fix this... or go washer..."
Nater13Nater13 posted an answer for this Whirlpool Duet GHW9150P Front Load Washer:
"Inspect the water level pressure switch tube, run diagnostic cycle, and see if there are..."
Nater13Nater13 posted an answer for this Whirlpool Washing Machines:
"Long Drain. You have a damaged pump or it is clogged with debris..."
Nater13
Nater13 posted an answer for this Whirlpool LTE5243D Top Load Stacked Washer/Dryer:
"Your most likely suspect is the "ATC" switch... it is the only part that can interfere..."
Nater13
Nater13 posted an answer for this Whirlpool OEM FSP Washing Machine Pump:
"Yes, you got hosed. If the machine is in your basement, and there is not risk of..."
Nater13Nater13 posted an answer for this Whirlpool Washing Machines:
"The grease would end up on your garments.. replace the drive shaft and bearings, then STOP..."
Nater13
Nater13 posted an answer for this Whirlpool GHW9100L Front Load Washer:
"The pulley is made of softer metal than the shaft, so it will probably need replacement..."
Nater13
Nater13 posted an answer for this Whirlpool GHW9400 Front Load Washer:
"chlorine bleach is a highly corrosive addition to laundry that is not necessary... try..."
Nater13Nater13 posted an answer for this Whirlpool Duet GHW9150P Front Load Washer:
"Your original problem is likely to have damaged the bearings and the spin tub shaft... the..."
Nater13
Nater13 posted an answer for this Whirlpool Calypso GVW9959K Top Load Washer:
"If it is a Calypso, abandon it immediately... it is amazing you still have it. One of the..."
Nater13Nater13 posted an answer for this Whirlpool Dryers:
"Replace the door switch."
Nater13Nater13 posted an answer for this Dryers:
"Yes, read your owner's manual."
Nater13Nater13 posted an answer for this Dryers:
"Gas solenoid coils, you can check the flame (radiant) sensor with a continuity check."
Nater13Nater13 posted an answer for this Dryers:
"The motor is failing."
Nater13
Nater13 posted an answer for this Kenmore Kitchen Ranges:
"PF stands for power failure. Check the voltage at the wall outlet and make sure the..."
Nater13
Nater13 posted an answer for this Refrigerators:
"Purge the defrost drain tube with some warm water in a turkey baster... it will be in the..."
Nater13
Nater13 posted an answer for this DeLonghi Ovens:
"Sounds like an improperly grounded element in the circuit... If an element or wire makes..."
Nater13Nater13 posted an answer for this Kenmore Ovens:
"Then you have a bad BAKE element, or the relay on the control board has failed. I would..."
Nater13Nater13 posted an answer for this Maytag Ovens:
"If you do not see an orange glow from near the burner tube, when a BAKE selection is made,..."
Nater13Nater13 posted an answer for this Ovens:
"Don't use self-clean feature, it is more likely to cause problems than to get the machine..."
Nater13Nater13 posted an answer for this Ovens:
"Communication error- disconnect and reconnect the wires on the main control board... these..."
Nater13Nater13 posted an answer for this Ovens:
"That will not work. Get a meter and test the lock position microswitches and replace the..."
Nater13Nater13 posted an answer for this Ovens:
"Help Me Find My Model Number"
Nater13Nater13 posted an answer for this Magic Chef Ovens:
"To need but for get a dictionary? Help Me Find My Model Number"
Nater13Nater13 posted an answer for this Refrigerators:
"The machine is set too cold. Yes, this can happen when the machine goes from being used..."
Nater13
Refrigerators 102 answers
Washing Machines 101 answers Dryers 98 answers
Ovens 75 answers
Kitchen Ranges 74 answers Freezers 53 answers
Cars & Trucks 28 answers Dishwashers 27 answers
Garden 6 answers
Microwave Ovens 5 answers
