2
Rick Amick posted an answer for this Chevrolet Cars & Trucks:
"Maybe the shift valve in the valve body is sticking, or shifter adjustment? Might be wise..."
Rick Amick
Rick Amick posted an answer for this 2003 Cadillac CTS:
"Check and see if you have any fluids dripping on to the exhaust manifold or pipe."
Rick AmickRick Amick posted an answer for this Jeep Cars & Trucks:
"Sounds like it could very well be the fuel pump."
Rick AmickRick Amick posted an answer for this 2002 Chevrolet Silverado 1500:
"I have an 02 also and the only fuse boxes I'm aware of is the one under the hood right..."
Rick Amick
Rick Amick posted an answer for this 1991 Toyota Pickup:
"1342 on 4 cylinder 123456 on V6"
Rick Amick
Rick Amick posted an answer for this 1966 Chevrolet Corvette:
"Are you needing the procedure or the specs?"
Rick AmickRick Amick posted an answer for this 1972 Chevrolet Corvette:
"Neutral"
Rick AmickRick Amick posted an answer for this 1987 Chevrolet S-10 Pickup:
"1-3-4-2"
Rick AmickRick Amick posted an answer for this 1984 Chevrolet El Camino:
"First you will need a chrome removal tool KD 2038 or similar. You slide it under the edge..."
Rick Amick
Rick Amick posted an answer for this 1994 Chevrolet Camaro:
"With the window down, reach inside and find a place to the rear on the door that you can..."
Rick AmickRick Amick posted an answer for this 1985 Chevrolet C1500:
"I have had good luck with Echlin caps and rotors that are from NAPA. You are going to need..."
Rick AmickRick Amick posted an answer for this Chevrolet Cars & Trucks:
"What engine do you have in the car? Your tune up will consist of distributor cap , rotor,..."
Rick Amick
Rick Amick posted an answer for this 2003 Chevrolet Tahoe:
"Sounds like the belt is slipping, or possibly a problem with AC compressor."
Rick AmickRick Amick posted an answer for this 1983 Chevrolet Monte Carlo:
"Ok I believe the butterfly that you are refering to is yes the choke. Normally the choke..."
Rick Amick
Rick Amick posted an answer for this 1992 Chevrolet Caprice:
"I doubt that shop did anythng wrong by just working on the doors. I would first check and..."
Rick Amick
Rick Amick posted an answer for this 1999 Chevrolet Cavalier:
"It sounds like the hyd. clutch is not working. If the clutch won't release then you can't..."
Rick Amick
Rick Amick posted an answer for this 2007 Chevrolet Avalanche LTZ:
"I would have someone check out the rotors for you."
Rick AmickRick Amick posted an answer for this 1988 Chevrolet Camaro:
"You should have a purple wire that goes to the starter,plus the red one from pos on..."
Rick AmickRick Amick posted an answer for this 1978 Chevrolet C1500:
"Try manually compressing the rod on the vacuum diaphram as if it were working and see if..."
Rick AmickRick Amick posted an answer for this 1980 Chevrolet Corvette:
"I would go back and get it on TDC and see where your rotor is. Make sure you have it in..."
Rick Amick
Rick Amick posted an answer for this 1998 Chevrolet Cavalier:
"After you have had it out for a drive shut it off and wait a couple minutes then check..."
Rick AmickRick Amick posted an answer for this 2006 Chevrolet Silverado 2500HD 2WD:
"Turning the screw should be all you have to do. Not sure which way but if you have it..."
Rick Amick
Rick Amick posted an answer for this 2000 Nissan Xterra:
"On 4 cyl engines the knock sensor is on the side of the block. On V6 engines it is located..."
Rick Amick
Rick Amick posted an answer for this 2003 Nissan Xterra:
"There should be just a clip on the connector that pops up and releases from the bulb."
Rick Amick
Rick Amick posted an answer for this 2002 Nissan Xterra:
"Check the fuse box and see if you have a bad fuse."
Rick Amick
Rick Amick posted an answer for this 1994 Chevrolet Corsica:
"It sounds like it is time to remove the door panel and check the rod that runs from the..."
Rick Amick
Rick Amick posted an answer for this 1999 Chevrolet Monte Carlo:
"The odd numbers 1,3,5 should be on the driver side and the even 2,4,6 on passenger side."
Rick AmickRick Amick posted an answer for this 1992 Chevrolet G20:
"The resevoir should be on the power steering pump If you are good on fluid then maybe you..."
Rick Amick
Rick Amick posted an answer for this 1993 Chevrolet K1500:
"K&N makes a different air intake system that is suppose to help. You might also check out..."
Rick Amick
Rick Amick posted an answer for this 1998 Chevrolet C1500:
"Myself I would give the fluid filter change a shot. If the fluid still looks good then..."
Rick AmickRick Amick posted an answer for this 1972 Chevrolet Corvette:
"So you replaced the vacuum modulator and Oring? There is also an O ring at the end of the..."
Rick Amick
Cars & Trucks 71 answers
Air Tools & Compressors 1 answer
