1
Anonymous posted an answer for this Kenwood KAC-729S Car Audio Amplifier:
"amp is dead.... fuse didnt act fast enough to save it..... it happens. get it repaired or..."
Anonymous
Anonymous posted an answer for this Car Audio & Video:
"check for defective rca wires. maybe a sub terminal has broken off? defective pre outs on..."
AnonymousAnonymous posted an answer for this Audiovox Car Audio & Video:
"turn gain down. or (input) its too high or you have your volume up way too high and your..."
Anonymous
Anonymous posted an answer for this Orion Cobalt 2105 XP Car Audio Amplifier:
"amp is in protect mode. check your wiring and make sure your sub is wired properly for..."
AnonymousAnonymous posted an answer for this Sony XM-1002HX Car Audio Amplifier:
"no there are no xplod amps that are 2 ohm stable. only 4 ohm stable."
Anonymous
Anonymous posted an answer for this Soundstream XTA880.2 Car Audio Amplifier:
"make sure the power wire isnt touching even a little bit....had the same problem with an..."
Anonymous
Anonymous posted an answer for this Jl Audio 500/1 Car Audio Amplifier:
"hook up the remote wire ( or make sure its hooked up good) check your ground! ground wire..."
Anonymous
Anonymous posted an answer for this Hifonics BRZ17001D Car Amp:
"hard to do because it is a VERY loud sub. turn the frequency down low on the amp so as..."
Anonymous
Anonymous posted an answer for this Orion CO800.1 Car Amp:
"i would check your speaker wiring.....also make sure you have a nice solid ground..."
Anonymous
Anonymous posted an answer for this Jl Audio 1000/1 Car Audio Amplifier:
"either a repair shop or buy a new one."
Anonymous
Anonymous posted an answer for this Boss RIP-595 Car Audio Amplifier:
"whats your problem. boss isnt good for any amps. fyi"
Anonymous
Anonymous posted an answer for this Boss Nxd45001 Car Amp:
"make sure your amp can hold either .5 ohms , 2 ohms or 8 ohms...... by my guess your amp..."
Anonymous
Car Audio & Video 12 answers
