Put new belt on my 2004 trailboss driven clutch only has one shim in it and that's the minimum my deflection is over 3 inches motor mounts look good am I missing something or can I adjust trans or motor.my center of clutches is a hair under 10 inches.my belt slips on primary a lot cleaned surfaces real good does anyone have advice to fix my deflection.
SOURCE: 1990 polaris trailboss , trans ,or clutch slips in water
Check for wore clutch belt and also check to see if your getting water in the clutch housing. If your getting water in the housing, your clutches could be corroded as well. There should be no water getting in that shroud.
SOURCE: Severe vibration in 96 sportsman 500. New belt,
Could be a few things. First I would check your drive belt to see if it's worn, if its good then could be two other things, Drive clutch bushings sticking or Excessive clearance between belt and sheave, you can fix by with a new beltadjust the clearance bychanging the number of shims.Also if your drive belt is less than 1 1/8 inch wide you probably need a new one. Hope this helped.
SOURCE: 90 polaris trailboss. 2x4. with
Secondary clutch is your problem, depending on internal set up, you will find they are seized or worn/jammed, replace and check belt as it would be fairly worn, dont forget to sand the smooth surfaces on front and rear pulley (where belt sits) up and down motion (not circular)
SOURCE: Clutch slipping on new bike
This is a new bike right? So it under warranty, so it would be best to bring it back to the dealer.
ATV Snow Plows
You either have the wrong belt or someone removed the shims from the driven clutch.
301 views
Usually answered in minutes!
×