Questions & Answers for: fuser assembly - Page 8

...off printer, check and reseat fuser. no luck. any suggestions? fuser was not hot... Replace fuser assembly is the fix Normal consumable, the lamp electrics (lamp, thermistor) will have blown. Part ...

...fuser assembly. To take it our, you need to do the following:- 1) remove the rear cover 2) remove the side cover 3) remove the top cover 4) remove the black paper guide at the back of the printer 5) ...

...fuser unit? Don't have a service manual and so far have not found anything on line. 1 Unplug the power cable. 2 Remove the paper delivery tray assembly 3 Remove two (2) screws from the right cover ...

...fuser unit. Your help will most be appreciated. 1 Unplug the power cable. 2 Remove the paper delivery tray assembly 3 Remove two (2) screws from the right cover assembly 4 Remove the right cover ...

HP 3505n message: 50.9 Fuser Error Fuser is HP 3505n message: 50.9 Fuser Error Fuser is hot Did everything the messages said.....any ideas Please replace the fuser assembly.

...fuser assembly. Any way to open fuser assembly? The steps to remove the fuser from the printer at quite lengthy and should be avoided if at all possible. Any way you can get to the paper as is? Also ...

...fuser assembly from the device, . CAUTION: The parts on the internal surface of the fuser are very hot. To avoid being burned, do not touch those parts. Using both hands, slowly and steadily remove ...

...fuser assembly is bad again or it isn't getting the proper voltage for the heat lamp to melt the resin toner. Also could be the rubber roller that pushes the heated toner into the paper but that ...

fuser assembly. hp 1010 printer takes the page in and cartridge works fine but paper continuously gets jammed near fuser assembly. Pls give me a solution. I have already wasted a lot of paper in this.

...problem ? Fuser Film error, Fuser film torn. Replace upper fuser assembly or entire fuser If fuser film is intact, clean the white patch on the film usually it gets dirty and wont be read by the ...