Questions & Answers for: open fuser - Page 9

...open latch C, but my fuser unit is on the inside of latch B, and doesn't require me to even open latch C to access. (see http://www.xerox.com/office/6250kb/,case=R1001037637) Need urgent help as I ...

...fuser motor 12 Open two (2) clips and remove one (1) clip to remove the fuser connector. 13 Unplug two (2) 3-pin optical encoder wires 14 Unplug the red high-voltage bias wire. 15 Remove the ...

diagram #4. Move these to the unlocked position and then open up latch C. This is an orange lever inside the printer on the left, behind the fuser assembly. Once you open this you can remove the fuser

...fuser. A fault "back cover open" appears. To clear you have to remove the drum / toner assembly and pull the paper out the front. Opening the back cover doesn't give access to this paper jam. ...

...fuser? Open the Unit Up, the Button on the Side opens the Printer. In the rear of the Printer you will notice the Element in the rear of the Printer. It is usually hot. Well there is latches as an ...

...where the fuser section is and how to get to it? Open the front door. Move the green lever to open the machine. The fuser is the last section the paper passes through before leaving the

...Open Heat Errors on the Samsung 4200 are caused by an interuption in powerflow thru the fuser unit. This is caused by one of two things. 1) The Power supply board is not putting out enough power to ...

...open, remove fuser assembly, dis-assemble up sleeve, check switch continuity, if no continuity, remove switch & just hit gently on aluminum capsule till continuity comes,make sure it should not ...

open heat error open heat eror Open heat error is caused by a bad fuser. Replace the fuser assembly.

...fuser is having issues. Open the top, and release the fuser using the release clip on either side of the fuser. Lift the fuser up a couple of inches then place it back down ensuring that it is well ...