You may be able to obtain a service manual for the Creda T620CW dryer by contacting the manufacturer or a local appliance repair service. They may be able to provide you with a copy of the manual or direct you to a reliable source. Alternatively, you can search for the manual online through websites that specialize in appliance manuals or user forums where others may have shared the manual.
There is no definitive instructions to so this. Normally, go around to the back and remove screws or press catches to loosen and remove the top. Remove screws at the front kickplate. Pull the door and front forward, remembering that there are wires attached. Replace the latch and rebuild.
https://www.google.com/search?q=Blomberg+Dryer+dv17542+replace+lock+body+assembly
similar to this on a Whirlpool
..
They always screech when the belt slips. There are usually only 2 reasons this happens.
The drum slides at the lower front are worn out and creating too much friction.
Or
The rear drum bearing has worn out, and again too much friction.
..
The screws and spacers for the device are lost. However, the mounting hardware could easily be replaced by three screws and corresponding plastic bushings/spacers. Unfortunately, I could not find any information about a fuse for this device. If you're still experiencing issues, I recommend contacting the manufacturer or a certified repair technician.
Two Beeps on my Bosch WTE84100au Condensing Dryer means a thermal overload but also means one of the thermal sensors is faulty .... as if it is always on.
Open the door, pull out the lint catcher and clean around the silver probe (it's like a shiny 1/8" nail sticking into the cavity below the lint catcher). If it still doesn't work (and still 2 beeps), just flick it lightly a couple of times. If it still doesn't work, flick again from the other direction.
