Kole audio KMX-15 Car Subwoofer - Answered Questions & Fixed issues
Trying to put ported reccomended subs in sealed box.
Well, 1.6 cubic foot for a 15 is not nearly enough. A ported box for 1 15 should be in atleast 3 cubes by itself. I suggest building a new box yourself or getting someone else to do it for you. If factory specs on those subs is no larger than 3 cubes per sub then I'd get the box built to 3 cubes per sub after all displacement and tune it in the upper 30's range. Putting big subs like that in a small sealed enclosure can and will damage a sub. and if you try to port an enclosure that is too small to begin with that will also hurt the woofer. Do it right or learn the hard way.
5/31/2010 6:16:36 PM •
Kole audio...
•
Answered
on May 31, 2010
•
192 views
Vr3 200watt amplifier red light problems
Why does the Power / Protect LED switch between green & red?
Suspect the power and ground connections, insufficient wire size to carry the current demand,
or an improper impedance load (especially if bridging two channels into one.
Why does the Power / Protect LED stay red?
This typically indicates that one or more of the MOSFET output transistors has shorted
This is straight out of the user manual.
1/23/2026 8:37:18 PM •
Car Audio &...
•
Answered
on Jan 23, 2026
•
247 views
How to set time and alarm in KADIO KD-3810N
Insert Batteries: First, insert 2 AA batteries into the back of the clock.
Access Time Setting Mode:
Press and hold the Mode button for 5-10 seconds until the clock enters the setting mode.
Adjust Time:
Once in the setting mode, use the Up and Down buttons to change the time, month, and date.
Press the Mode button to cycle through the different settings.
Set Hour and Minute:
When you reach the time setting, adjust the hour and minute using the Up and Down buttons.
Press the Mode button again to move to the next setting (e.g., month, date).
Exit Setting Mode:
After setting the time, press the Mode button to exit the setting mode.
5/7/2025 9:51:36 AM •
Car Audio &...
•
Answered
on May 07, 2025
•
158 views
Panasonic SE-b80 stereo power amplifier. Where can I get a schematic diagram?
Besides the 3-wire cable that has Left-Ground-Right inputs, there is a cable connected to the transformer. That can be cut, was used to bring power to the HiFi set.The other wire bundle with 7 wires, (J107) is the control. You can cut and use the 2 wires on the right of the connector as the on/off contact. Connecting these 2 wires makes the amp turn on.
3/29/2025 4:37:14 PM •
Car Audio &...
•
Answered
on Mar 29, 2025
•
295 views
Manual
Manual for dixon car stereo dn3238m3
1/23/2025 11:42:42 PM •
Car Audio &...
•
Answered
on Jan 23, 2025
•
603 views
Not finding what you are looking for?
